Material Safety Data Sheet - Scrubs

Section 01 Identification

Home

MSDS No 700 series. Rev 2      Date: 5 July, 2007
Domestic Trade Name: Scrubs
Note: CAS Registry Numbers Are Not Applicable to Formulated Products.

Section 02 Statement Of Hazardous Nature

Not classified as hazardous according to the criteria of Worksafe Australia

Section 03 Physical and Health Hazardous Ingredients

INGREDIENTS

CAS No.

Range (w/w)

Ingredients not considered hazardous by Worksafe Australia.

to

100%

Section 04 Physical and Chemical Characteristics

Water Solubility: Complete
Melting / Freezing Point: Lower than 0o C.
Appearance: Clear brown liquid.
Specific Gravity (Water = 1): 1.01
pH of Concentrate: In concentrate: 11.3,  In working/use solution: 10.0.
Odour: Citrus cleaner with a butyl odour

Section 05 Physical Hazard Data

Flash Point: > 65°C
Flammable Limits: Not determined.
Fire Fighting Media: Water Spray, CO2, Alcohol foam, Dry chemical. Treat primary cause of fire.
Special Fire Fighting Procedures: None
Fire / Explosion Hazards: None known.

Section 06 Reactivity Data

Stability: Stable.
Hazardous Polymerisation: Will not occur.
Conditions To Avoid: Long exposure to materials containing copper, aluminium and strong oxidising agents.
Incompatible Materials: Strong oxidising or reducing agents.

Section 07 Health Hazard Data

Oral Toxicity: Capable of causing irritation if swallowed.
Skin Toxicity The product may cause irritation and can defat the skin with continual use.
Carcinogenicity: None of the individual materials in this formulation are listed as carcinogens in the “List of Designated Hazardous Substances” {NOHSC:10005(1994)].

Section 08 Emergency First Aid

For ingestion of concentrate: If poisoning occurs, contact a doctor or Poisons Information Centre. If swallowed, do NOT induce vomiting. Give a glass of water.
For Skin: If skin contact occurs, remove contaminated clothing and wash skin thoroughly.
For Eyes: If in eyes, hold eyes open, flood with water for at least 15 minutes and see a doctor

Section 09 Occupational Control Procedures

Ventilation: Use with adequate ventilation. Working solution should not present any specific hazard
Respiratory Protection: Not required under normal working/use conditions.
Eye Protection: Not normally required. Use if mist will get into the eyes in specific applications.
Skin Protection: Use gloves if hands will be continuously in solution. Not normally necessary in general use.
Personal Hygiene: As in handling any detergent, wash thoroughly after use.

Section 10 Precautions for Safe Handling Storage and Use

Precautionary Measures: Avoid contact with eyes and prolonged contact of concentrate with skin. Avoid breathing misted vapours. Use with adequate ventilation. Do not store at elevated temperatures.
Spills Clean-up Procedures: Ensure adequate ventilation. Wear appropriate protective clothing. Absorb with dry earth, sand or a similar material, shovel up and dispose of in an area approved by local authority by-laws.
Disposal Method: Small spillages may be safely mopped upor flushed to drain with water, if permitted.
Fire / Explosion Hazard: In a fire, overheated drums may rupture but the product will not burn until the water boils off. Fire fighters should wear self-contained breathing apparatus to minimise risk of exposure to vapour or products of combustion. Extinguish fires with water spray, foam, carbon dioxide or dry chemical powder.

KEEP OUT OF REACH OF CHILDREN

The information contained in this MSDS is specific to the product when handled and used neat. This product when diluted may be classified as non-hazardous and may not require the same control measures as the neat product.

Check with Solo Pak Customer Service Centre if in doubt. Solo Pak makes no warranty, expressed or implied, as to the accuracy, completeness or reliability of this information, except that such information is, to the best of Solo Pak’s knowledge and belief, accurate as of 5 July, 2007

Home